Cisco Catalyst 3850 Getting Started Guide

16
Catalyst 3850 Switch Getting Started Guide
OL-26778-02
Connecting the StackPower Cables (Optional)
Figure 6 Example of a StackWise cabling configuration
Connecting the StackPower Cables (Optional)
Always use a Cisco-approved StackPower cable to connect the switches.
Note The Catalyst 3850 ports accept either the yellow or the green end of the StackPower cable.
Align the connector and connect the StackPower cable to the S-PWR port on the switch rear panel and
finger-tighten the screw. Connect the other end of the cable to the port on the other switch and
finger-tighten the screw. Avoid overtightening the screws.
Figure 7 Connecting the StackPower cable to the S-PWR port
Caution Removing and installing the StackPower cable can shorten its life. Do not remove and insert the cable
more often than is necessary.
334340
CONSOLE
MGMT
CONSOLE
MGMT
CONSOLE
MGMT
CONSOLE
MGMT
PWR-C1-715WAC PWR-C1-715WAC
PWR-C1-715WAC PWR-C1-715WAC
PWR-C1-715WAC PWR-C1-715WAC
PWR-C1-715WAC PWR-C1-715WAC
AC OK
AC OK
PWR-C1-715WAC
PS OK
S-PWR
XPS
S-PWR
334330

Cisco Catalyst 3850 Specifications

General

Stacking Bandwidth	480 Gbps
Max Stacking Units	9
Form Factor	Rack-mountable
RAM	4 GB
Flash Memory	4 GB
Operating System	Cisco IOS XE
Model	Catalyst 3850
Ports	24 or 48 Gigabit Ethernet ports
Uplink Interfaces	4 x 1GE, 2 x 10GE, or 4 x 10GE
Power Supply	Redundant power supplies
Dimensions	44.5 x 44.8 x 4.45 cm
Weight	7.6 kg
Features	IPv6
Power over Ethernet (PoE)	PoE, PoE+, UPOE (varies by model)
Operating Temperature	0 to 40°C