Name: Cisco Catalyst 3850
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Catalyst 3850 Switch Getting Started Guide

OL-26778-02

Running Express Setup

Use Express Setup to enter the initial IP information. This action enables the switch to connect to local

routers and the Internet. You can access the switch through the IP address for further configuration.

Note To use the CLI-based initial setup program, see Appendix C, “Configuring the Switch with the

CLI-Based Setup Program,” in the switch hardware guide.

You need this equipment:

• PC or laptop with Windows Vista, XP, or 2000

• Browser (Internet Explorer 5.5, 6.0, 7.0, Firefox 1.5, 2.0, and 3.0) with JavaScript enabled

• Straight-through or crossover Category 5 Ethernet cable

Note Before running Express Setup, disable any pop-up blockers or proxy settings in your browser and any

wireless client running on your PC or laptop.

Step 1

Make sure that nothing is connected to the switch.

Step 2

During Express Setup, the switch acts as a DHCP server. If your PC or laptop has a static IP address, temporarily

change your PC or laptop settings before you use DHCP.

Note Write down the static IP address. You will need this IP address in Step 14.

Step 3

Install the power supply modules. See the “Power Supply Installation” chapter in the Catalyst 3850 Switch Hardware

Installation Guide for instructions.

http://www.cisco.com/go/cat3850_hw

ACTV

333407

Catalyst 3850 48 PoE+

01X

12X

13X

C3850-NM-4-1G

36X

37X

13X

Other manuals for Cisco Catalyst 3850

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst 3850 and is the answer not in the manual?

General