Name: Cisco Catalyst 3850
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Figure 73: Basic Settings - Device ID and Location Settings

Step 3 In the Device Management Settings section, assign an IP address to the management interface. Ensure

that the IP address you assign is part of the subnet mask you enter.

Step 4 Optionally, enter an IP address to specify the default gateway.

Step 5 To enable access to the device using telnet, check the Telnet check box.

Step 6 To enable secure remote access to the device using Secure Shell (SSH), check the SSH check box.

Step 7 Check the VTP transparent mode check box to disable the device from participating in VTP.

If you did not select Wired Network, in the earlier step, continue to the next screen to verify your configuration

on the Day 0 Config Summary screen, and click Finish. To automatically configure your device based on

a site profile, click Setup Options, and select Wired Network.

Catalyst 3850 Switch Hardware Installation Guide

91OL-26779-05

Configuring the Switch

Configuring Basic Device Settings

Other manuals for Cisco Catalyst 3850

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst 3850 and is the answer not in the manual?

General