Cisco Catalyst 9600 Series User Manual

MeaningLED Position or ColourLED type
Indicates that the environmntal monitors are normal.Green
SYSTEM
Indicates a minor fault such as partial power supply
or fan failure.
Amber
Indicates a major fault. For example, situations where
the temperature of the supervisor module exceeds the
critical threshold.
Red
Indicates that the supervisor module is operational
and is functioning as the active supervisor (in
redundant supervisor module configurations).
Green
ACTIVE
Indicates one of the following:
• ROMMON mode
• Supervisor module is functioning as the standby
supervisor (in redundant supervisor module
configurations)
Amber
Indicates Graceful Insertion and Removal (GIR) of
the module.
Blinking Amber
Line Card LEDs
Table 13: Line Card LEDs
MeaningLED Position or ColourLED type
Module is receiving beacon signal.Blue
BLUE BEACON
Port link is up but there is no packet activity.Green
PORT LINK
Port link is up and indicating packet activity.Blinking Green
Port link is disabled, that is, administratively down.Amber
No signal is detected, the link is down, or the port is
not connected.
Off
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
99
LEDs
Line Card LEDs

Cisco Catalyst 9600 Series Specifications

General

Series	Catalyst 9600 Series
Category	Switch
Switching Capacity	Up to 25.6 Tbps
Software	Cisco IOS XE
Form Factor	Modular chassis
Purpose	Enterprise campus core and distribution
Ports	10G, 25G, 40G, 100G, 400G
Redundancy	Yes, supports redundant power supplies and fans
Stacking	Virtual Stacking supported
Security	Advanced security features including MACsec encryption
Management	Cisco DNA Center, CLI, SNMP
Uplink Ports	40G, 100G
Power Supply	Redundant, hot-swappable
Operating Temperature	0°C to 45°C (32°F to 113°F)
Port Density	Up to 384 ports
Weight	Starting at 75 lbs (34 kg)
Modular Slots	Up to 6 line card slots