Cisco Catalyst 9600 Series User Manual

CHAPTER 5
Installing a Power Supply Unit
• Required Tools and Equipment, on page 75
• Removing and Installing Power Supply Modules, on page 75
• Connecting to a Power Source, on page 82
• Verifying the Power Supply Installation, on page 86
• Removing and Installing Power Supply Blanks, on page 86
• Finding the Serial Number, on page 90
Required Tools and Equipment
Obtain these tools:
• A Phillips-head screwdriver
• A 10-mm torque driver (with a 3-inch shaft, at a minimum)
• Wire-stripping tool
• Wire crimping tool
Removing and Installing Power Supply Modules
The chassis supports field-replaceable and hot-swappable AC-input and DC-input power supply modules.
You can install a mix of AC-input and DC-input modules in the chassis. This section describes how to remove
and install both kinds of modules
• In a redundant mode, you do not have to power down the switch to replace or upgrade the power supplies.
• In the combined mode, the module is still hot-swappable as long as the difference between total output
power and the total used power is greater than the capacity of the module being removed.
Total output power – Total used > Capacity of power supply module being removed.
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
75

Cisco Catalyst 9600 Series Specifications

General

Series	Catalyst 9600 Series
Category	Switch
Switching Capacity	Up to 25.6 Tbps
Software	Cisco IOS XE
Form Factor	Modular chassis
Purpose	Enterprise campus core and distribution
Ports	10G, 25G, 40G, 100G, 400G
Redundancy	Yes, supports redundant power supplies and fans
Stacking	Virtual Stacking supported
Security	Advanced security features including MACsec encryption
Management	Cisco DNA Center, CLI, SNMP
Uplink Ports	40G, 100G
Power Supply	Redundant, hot-swappable
Operating Temperature	0°C to 45°C (32°F to 113°F)
Port Density	Up to 384 ports
Weight	Starting at 75 lbs (34 kg)
Modular Slots	Up to 6 line card slots