Cisco Catalyst 9600 Series User Manual

Figure 39: Detaching the Power Supply Module from the Slot
Release latch1
Step 5 Grasp the power supply module handle with one hand; place your other hand underneath to support the bottom
of the power supply. Slide the power supply module out fully.
Figure 40: Sliding the Power Supply Module Out
Do not leave any power supply slot open for any amount of time while the system is powered up.
Before inserting a new power supply unit, for instance, when replacing the unit, ensure that there
are no foreign, conductive or other objects, or debris in the slot.
Caution
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
78
Installing a Power Supply Unit
Removing a Power Supply Module

Cisco Catalyst 9600 Series Specifications

General

Series	Catalyst 9600 Series
Category	Switch
Switching Capacity	Up to 25.6 Tbps
Software	Cisco IOS XE
Form Factor	Modular chassis
Purpose	Enterprise campus core and distribution
Ports	10G, 25G, 40G, 100G, 400G
Redundancy	Yes, supports redundant power supplies and fans
Stacking	Virtual Stacking supported
Security	Advanced security features including MACsec encryption
Management	Cisco DNA Center, CLI, SNMP
Uplink Ports	40G, 100G
Power Supply	Redundant, hot-swappable
Operating Temperature	0°C to 45°C (32°F to 113°F)
Port Density	Up to 384 ports
Weight	Starting at 75 lbs (34 kg)
Modular Slots	Up to 6 line card slots