Name: Cisco Catalyst C9300-48P
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Figure 27: Example of a StackPower Stack with a Failover Condition

In the following figure, StackPower port B on the center switch has failed and the stack partitions into two

stacks. The top two switches share power, and the bottom switch is now a separate stack. After initial failure

of cable 2, any further failure of a port is considered a double fault, which a StackPower cannot handle. A

double fault could result in unintended high priority ports being shut. If you are unable to physically restore

a bad cable, adjust port priorities and restore any offline supplies, as available.

Figure 28: Example of a Partitioned StackPower Stack with a Failover Condition

Installing the Switch

Rack-Mounting

Installation in racks other than 19-inch racks requires a bracket kit not included with the switch.

Cisco Catalyst 9300 Series Switches Hardware Installation Guide

Installing a Switch

Installing the Switch

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst C9300-48P and is the answer not in the manual?

Cisco Catalyst C9300-48P Specifications

General