Cisco CP-7942G User Manual

4-21
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 7.0
OL-15483-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
Recording Tone
Duration
Indicates the length of time in milliseconds for
which the beep tone plays.
If the value you configure here is less than one
third the interval, then this value overrides the
default provided by the Network Locale.
Range: 0 to 3000
Note For some Network Locales that use a
complex cadence, this setting applies
only to the first beep tone.
See also: Recording Tone
From Cisco Unified Communications Manager
Administration, choose Device
> Phone > Phone
Configuration.
Wideband Headset Indicates whether wideband is enabled or
disabled for the headset.
Default: Disabled
• If Wideband Headset UI Control is enabled,
you or the user can use the phone and choose
> User Preferences > Audio
Preferences > Wideband Headset.
• If Wideband Headset UI Control is disabled,
from Cisco Unified Communications
Manager Administration, choose Device >
Phone > Phone Configuration to set this
value.
Note If you allowed this option to be user
controllable (in the Wideband Headset UI
Control option), the user-configured value
takes precedence.
Enterprise Advertise
G.722 Codec
Enables/disables Cisco Unified IP Phones to
advertise the G.722 codec to Cisco Unified
Communications Manager. If enabled (default),
and if each endpoint in the attempted call supports
G.722 in its capabilities set, Cisco Unified
Communications Manager will choose G.722
for the call.
Note When a phone is registered with a Cisco
Unified Communications Manager that
does not support this setting, the default
is “Disabled.”
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.
Device Advertise
G.722 Codec
Allows you to override the Enterprise Advertise
G.722 Codec on a per-phone basis.
The default is “Use System Default,” which
means the value configured for the Enterprise
Advertise G.722 Codec parameter gets used.
From Cisco Unified Communications Manager
Administration, choose Device > Phone.
Table 4-14 Media Configuration Menu Options (continued)
Option Description To Change

Cisco CP-7942G Specifications

General

Brand	Cisco
Model	CP-7942G
Category	IP Phone
Language	English