Cisco CRS-1 - Carrier Routing System Router

3-5
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers egressq queue drr
show controllers egressq queue drr
To display queue information of the Deficit Round Robin (DRR) profile table, use the show controllers
egressq queue drr command in EXEC mode.
show controllers egressq queue drr {min | max} location node-id
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Command History
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs. If you suspect user group assignment is preventing you from using a command, contact your
AAA administrator.
Task ID
Examples The following example shows how to use the show controllers egressq queue drr command:
RP/0/RP0/CPU0:router# show controllers egressq queue drr max location 0/6/cpu0
Queue Max DRR Profile Table
----------------------------------
Index | Value (bytes)
0 | 0
1 | 88
2 | 176
3 | 264
4 | 352
5 | 440
6 | 528
7 | 616
max Maximum limit of the DRR profile table.
min Minimum limit of the DRR profile table.
location node-id Egress queue manager location.The node-id argument is entered in
the rack/slot/module notation.
Release Modification
Release 4.0.0.T This command was introduced.
Release 4.0.1 No modification.
Release 4.0.2 No modification.
Task ID Operations
drivers read