3-17
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers egressq group ntb
show controllers egressq group ntb
To display the negative token bucket (NTB) limit table information of the egress queue manager, use the
show controllers egressq group ntb command in EXEC mode.
show controllers egressq group ntb {min | max} location node-id
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Command History
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs. If you suspect user group assignment is preventing you from using a command, contact your
AAA administrator.
Task ID
Examples The following example shows how to use the show controllers egressq group ntb command:
RP/0/RP0/CPU0:router# show controllers egressq group ntb max location 0/6/cpu0
Group Max Negative TB Limit Table
----------------------------------
Index | Value (bytes)
0 | 76800
1 | 153600
2 | 230400
3 | 307200
4 | 384000
5 | 460800
6 | 537600
max Maximum limit of the DRR profile table.
min Minimum limit of the DRR profile table.
location node-id Egress queue manager location.The node-id argument is entered in
the rack/slot/module notation.
Release Modification
Release 4.0.0.T This command was introduced.
Release 4.0.1 No modification.
Release 4.0.2 No modification.
Task ID Operations
drivers read
To Next Page
Loading...
