Cisco CRS-1 - Carrier Routing System Router Migration Guide

3-20
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers egressq port bpmap
show controllers egressq port bpmap
To display back pressure map table information of the egress queue manager, use the show controllers
egressq port bpmap command in EXEC mode.
show controllers egressq port bpmap location node-id
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Command History
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs. If you suspect user group assignment is preventing you from using a command, contact your
AAA administrator.
Task ID
Examples The following example shows how to use the show controller egressq bpmap command:
RP/0/RP0/CPU0:router# show controller egressq port bpmap location 0/3/cpu0
---------------------------------------------------
Tor Asic HW BP Map Table Dump
---------------------------------------------------
Index Plim 0 Map Plim 1 Map
---------------------------------------------------
0 0 7
1 1 65535
2 65535 8
3 2 9
4 3 65535
5 65535 10
6 4 11
7 5 65535
location node-id Egress queue manager location.The node-id argument is entered in
the rack/slot/module notation.
Release Modification
Release 4.0.0.T This command was introduced.
Release 4.0.1 No modification.
Release 4.0.2 No modification.
Task ID Operations
drivers read

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English