3-29
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
show controllers (Ethernet)
To display status and configuration information about the Ethernet interfaces on a specific node, use the
show controllers command in EXEC mode.
show controllers {GigabitEthernet | HundredGigE | TenGigE} interface-path-id [all | bert |
control | internal | mac | phy | regs | stats | xgxs]
Syntax Description
Command Default No default behavior or values
Command Modes EXEC
Command History
{GigabitEthernet
|HundredGigE |
TenGigE }
Indicates the type of Ethernet interface whose status and configuration infor-
mation you want to display. Enter GigabitEthernet, HundredGigE,
TenGigE.
interface-path-id Physical interface or virtual interface.
Note Use the show interfaces command to see a list of all interfaces
currently configured on the router.
For more information about the syntax for the router, use the question mark
(?) online help function.
all Displays detailed information for the specified interface.
bert Displays BERT status information for the interface.
Note Not supported on the Cisco CRS 14-Port or Cisco CRS 20-Port
10-Gigabit Ethernet LAN/WAN-PHY Interface Module.
control
Displays configuration and control information for the interface.
internal Displays internal information for the interface.
mac Displays mac information for the interface.
phy Displays physical information for the interface.
regs
Displays register information for the interface.
stats Displays statistical information for the interface.
xgxs Displays information about the 10 Gigabit Ethernet Extended Sublayer
(XGXS).
Release Modification
Release 3.0 This command was first introduced on the Cisco CRS Router.
Release 3.5.0 Added GigabitEthernet and TenGigE keywords and support.
Release 4.0.0.T This command was first introduced on the Cisco CRS-3.
Release 4.0.1 Added HundredGigE keyword and support on the Cisco CRS-3.