Cisco CRS-1 - Carrier Routing System Router - Page 200

3-40
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
RP/0/RSP0/CPU0:Router# show controllers TenGigE 0/2/0/1
Operational data for interface TenGigE0/2/0/1:
State:
Administrative state: enabled
Operational state: Down (Reason: Link loss or low light, no loopback)
LED state: Red On
Media:
Media type: R fiber over 1310nm optics
Optics:
Vendor: CISCO-OPNEXT
Part number: TRF5011AA-LF003
Serial number: ONT1119104B
MAC address information:
Operational address: 001d.e5eb.96dd
Burnt-in address: 001d.e5eb.96dd
No unicast addresses in filter
No multicast addresses in filter
Autonegotiation disabled.
Operational values:
Speed: 10Gbps
Duplex: Full Duplex
Flowcontrol: None
Loopback: None (or external)
MTU: 1526
MRU: 1526
Inter-packet gap: standard (12)
The following example shows sample output for the base form of the show controllers TenGigE
command for the Cisco
CRS 14-Port 10-Gigabit Ethernet LAN/WAN-PHY Interface Module:
RP/0/RP0/CPU0:Router# show controllers TenGigE 0/1/0/0
Thu Oct 7 16:18:32.348 EST
Operational data for interface TenGigE0/1/0/0:
State:
Administrative state: disabled
Operational state: Down (Reason: Link loss or low light, no loopback)
LED state: Yellow On
Phy:
Media type: R fiber over 1310nm optics
Optics:
Vendor: CISCO-SUMITOMO
Part number: SXP3101NV-C1
Serial number: ECL120701L2
MAC address information:
Operational address: 0014.f294.6776
Burnt-in address: 0014.f294.6776
No unicast addresses in filter
Operating in multicast promiscuous mode
Autonegotiation disabled.
Operational values:
Speed: 10Gbps