EasyManua.ls Logo

Cisco CRS-1 - Carrier Routing System Router - Page 203

Cisco CRS-1 - Carrier Routing System Router
250 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-43
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
Driver constraints:
Min MTU: 64 bytes
Max MTU: 9216 bytes
Max speed: 10Gbps
Interface type: TenGigE
Management interface: No
Promiscuous mode: Yes
Allowed config mask: 0x27b
Cached driver state:
MTU: 1522 bytes
Burnt-in MAC address: 001d.353b.975e
Bundle settings:
Aggregated: No
Bundle MTU: 1514 bytes
Bundle MAC address: 001d.353b.975e
Port FSM state:
Port is disabled, due to an admin down condition.
Complete FSM state:
Admin down
Bundle admin up
Client admin up
Client admin tx not disabled
Port disabled
Port tx disabled
Hardware link down
IDB interface state information:
IDB bundle admin up
IDB client admin up
IDB client tx admin up
IDB error disable not set
0 Unicast MAC Addresses:
0 Multicast MAC Addresses:
0 Unicast Bundle MAC Addresses:
0 Multicast Bundle MAC Addresses:
Current Data
NP(01) Version : 0003
Structure Version : 2582
XAUI Interface : B
MAC addr : 00.1d.35.3b.97.5e
RX enabled : False
TX enabled : True
Obey Pause Frames : False
TX Pause Frames : False
Pause Re-TX Period : 3000000
Min Frame Len : 60
Max Frame Len : 1526
Ignore Errors : False
Add CRC : True
Strip CRC : True
Ignore CRC Errors : False
DMA Add CRC : False
DMA Strip CRC : False
Ignore Length Error: True
Pad Short Frames : True

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Related product manuals