Cisco CRS-1 - Carrier Routing System Router - Page 210

3-50
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
CONTROL (#1036): 00000000
ADDRESS_LOW (#1037): 53ffa780
ADDRESS_HIGH (#1038): 0000001b
MII_MGMT_CONFIG (#1039): 00000007
MII_MGMT_CMD (#1040): 00000000
MII_MGMT_ADDRESS (#1041): 00000000
MII_MGMT_DATA (#1042): 40000000
STAT_CONFIG (#1043): 00000007
MASK_R (#1044): 00000000
MASK_T (#1045): 00000000
COMP (#1046): 00100d24
MAC_CONFIG (#1047): ffffffff
INTERRUPT_C (#1048): 00000000
The following example shows sample output for the show controllers TenGigE all command for the
Cisco
CRS 14-Port 10-Gigabit Ethernet LAN/WAN-PHY Interface Module:
RP/0/RP0/CPU0:Router# show controllers TenGigE 0/1/0/0 all
Thu Oct 7 18:23:49.231 EST
Operational data for interface TenGigE0/1/0/0:
State:
Administrative state: disabled
Operational state: Down (Reason: Link loss or low light, no loopback)
LED state: Yellow On
Phy:
Media type: R fiber over 1310nm optics
Optics:
Vendor: CISCO-SUMITOMO
Part number: SXP3101NV-C1
Serial number: ECL120701L2
MAC address information:
Operational address: 0014.f294.6776
Burnt-in address: 0014.f294.6776
No unicast addresses in filter
Operating in multicast promiscuous mode
Autonegotiation disabled.
Operational values:
Speed: 10Gbps
Duplex: Full Duplex
Flowcontrol: None
Loopback: None (or external)
MTU: 1522
MRU: 1522
Inter-packet gap: standard (12)
Statistics for interface TenGigE0/1/0/0 (cached values):
Ingress:
Input total bytes = 0
Input good bytes = 0
Input total packets = 0
Input 802.1Q frames = 0
Input pause frames = 0
Input pkts 64 bytes = 0
Input pkts 65-127 bytes = 0
Input pkts 128-255 bytes = 0
Input pkts 256-511 bytes = 0