Cisco CRS-1 - Carrier Routing System Router - Page 223

3-63
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
Alarms:
Low RX power alarm
Warnings:
Low RX power warning
THRESHOLDS
High Alarm Low Alarm High Warning Low Warng
Temperature C 80.0 -15.0 75.0 -10.0
Voltage V 000.0000 000.0000 000.0000 000.000
Bias Current mA 100.0000 000.0000 080.0000 000.000
Transmit power mW 015.8480 001.2580 010.0000 001.990
Receive power mW 022.3870 000.1810 014.1250 000.280
Example: show controllers GigabitEthernet regs Command
RP/0/RSP0/CPU0:Router# show controllers GigabitEthernet 0/1/0/1 regs
MAC Registers for port: 1
GE MAC CFG (#0954): 704c5e5a
GPCS Config (#0147): 00000f08
GPCS Status (#0236): 000000ca
GSERDES Status (#0237): 0007fe09
Example: show controllers TenGigE regs Command
RP/0/RSP0/CPU0:Router# show controllers TenGigE 0/4/0/0 regs
MAC Registers for port: 0
CONFIG1 (#1034): 03100a1a
CONFIG2 (#1035): 040c2398
CONTROL (#1036): 00000000
ADDRESS_LOW (#1037): 53ffa780
ADDRESS_HIGH (#1038): 0000001b
MII_MGMT_CONFIG (#1039): 00000007
MII_MGMT_CMD (#1040): 00000000
MII_MGMT_ADDRESS (#1041): 00000000
MII_MGMT_DATA (#1042): 40000000
STAT_CONFIG (#1043): 00000007
MASK_R (#1044): 00000000
MASK_T (#1045): 00000000
COMP (#1046): 00100d24
MAC_CONFIG (#1047): ffffffff
INTERRUPT_C (#1048): 00000000
The following example shows sample output for the show controllers TenGigE regs command for the
Cisco
CRS 14-Port 10-Gigabit Ethernet LAN/WAN-PHY Interface Module:
RP/0/RP0/CPU0:Router# show controllers TenGigE 0/1/0/0 regs
Thu Oct 7 18:28:22.640 EST
LASI 802.3ae Registers:
=======================
Previous: LASI Status = 0x000c Rx Alarm Status = 0x0018 Tx Alarm Status = 0x0000
Current: LASI Status = 0x000c Rx Alarm Status = 0x0018 Tx Alarm Status = 0x0000
PMA/PMD 802.3ae Registers:
============================
Control = 0x2040 Status = 0x0082 Dev ID 0 = 0x0043 Dev ID 1 = 0xa400
Speed Ability = 0x0001 Devices 1 = 0x001e Devices 2 = 0x0000
Control 2 = 0x0007 Status 2 = 0xb581
Tx Disable = 0x0000 Rx Signal Detect = 0x0000
OUI 0 = 0x0000 OUI 1 = 0x0000