Cisco CRS-1 - Carrier Routing System Router

3-70
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
All of 10 clock/data recovery units are locked.
None of 10 TX FIFO has underflow/overflow condition.
None of 10 RX FIFO has underflow/overflow condition.
CFP section:
==============
CFP General Information:
Module Identifier: CFP
Ethernet Application Code: 100GE-LR4
Module State: Low Power
Power Class: 3
Maximum Power Consumption: 23000 mW
CFP Vendor Information:
Vendor Name: FINISAR CORP.
Vendor PN: FTLC1181RDNS-C1
Vendor SN: C22CS58
Vendor OUI: 0x0-0x90-0x65
Lot Code: 00
DATE CODE(YY/MM/DD): 2010/08/05
Hardware Version: 1.3
Firmware Version: 1.5
CFP UDI Information:
UDI Compliant: Yes
CISCO PID: CFP-100G-LR4
CISCO VID: VES1
CFP Detail Information:
…
Module Analog A/D value:
Power supply voltage : 3.2915 V
Temperature : 16.7917 degC
Network lane A/D value:
Lane 0 Tx power: 0.0 mW (-40 dBm)
Lane 1 Tx power: 0.0 mW (-40 dBm)
Lane 2 Tx power: 0.0 mW (-40 dBm)
Lane 3 Tx power: 0.0 mW (-40 dBm)
Lane 0 Rx power: 0.0 mW (-40 dBm)
Lane 1 Rx power: 0.0 mW (-40 dBm)
Lane 2 Rx power: 0.0 mW (-40 dBm)
Lane 3 Rx power: 0.0 mW (-40 dBm)