Cisco Firepower 4110 User Manual

Cisco Preparative Procedures & Operational User Guide
© 2016 Cisco Systems, Inc. All rights reserved.
1) Enter system mode:
Firepower-chassis# scope system
2) Enter system services mode:
Firepower-chassis /system # scope services
3) Configure the system clock:
Firepower-chassis /system/services # set clock month day year hour min sec
For month, use the first three digits of the month. Hours must be entered using the 24-hour format,
where 7 pm would be entered as 19.
System clock modifications take effect immediately. You do not need to commit the buffer.
Set the Date and Time Manually via GUI
1) Choose Platform Settings > NTP.
2) Click the Time Synchronization tab.
3) Under Set Time Source, click Set Time Manually.
4) Click the Date drop-down list to display a calendar and then set the date using the controls available
in the calendar.
5) Use the corresponding drop-down lists to specify the time as hours, minutes, and AM/PM.
6) Click Save.

Cisco Firepower 4110 Specifications

General

Power Supply	Dual, hot-swappable
Form Factor	1RU
Firewall Throughput (Multiprotocol)	10 Gbps
Number of 10GE (SFP+) Interfaces	8
Number of 40GE (QSFP+) Interfaces	2
Redundant Power Supply	Yes
Memory	32 GB
Ports	8 x 10GE, 2 x 40GE
Concurrent Sessions	8 Million
Number of 10/100/1000 Interfaces	8
Maximum Connections	8 Million
Management Ports	1 x RJ45
Data Ports	8 x 10GE, 2 x 40GE
Processor	Intel Xeon E5-2600