Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2009 Cisco Systems, Inc. All rights reserved.
Configuring MQC Support for IP Sessions
First Published: March 21, 2008
Last Updated: March 2, 2009
The MQC Support for IP Sessions feature provides modular quality of service (QoS) command-line
interface (CLI) provisioning on Cisco Intelligent Services Gateway (ISG) IP sessions. It makes the full
set of modular QoS CLI (MQC) syntax available for the sessions, whether they are configured locally or
downloaded from a remote authentication, authorization, and accounting (AAA) server.
Finding Feature Information
For the latest feature information and caveats, see the release notes for your platform and software
release. To find information about the features documented in this module, and to see a list of the releases in
which each feature is supported, see the “Feature Information for MQC Support for IP Sessions” section on
page 7.
Use Cisco Feature Navigator to find information about platform support and Cisco IOS XE software
image support. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on
Cisco.com is not required.
Contents
• Restrictions for MQC Support for IP Sessions, page 2
• Information About MQC Support for IP Sessions, page 2
• How to Configure MQC Support for IP Sessions, page 3
• Configuration Examples for MQC Support for IP Sessions, page 5
• Additional References, page 6
• Feature Information for MQC Support for IP Sessions, page 7
To Next Page
Loading...
Need help?
General