Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2009 Cisco Systems, Inc. All rights reserved.
Configuring ISG Integration with SCE
First Published: February 22, 2008
Last Updated: March 2, 2009
Intelligent Services Gateway (ISG) is a Cisco IOS and Cisco IOS XE software feature set that provides
a structured framework in which edge devices can deliver flexible and scalable services to subscribers.
This module describes how to configure ISG and Cisco Service Control Engine (SCE) to function as a
single policy enforcement point for subscriber sessions.
Finding Feature Information
For the latest feature information and caveats, see the release notes for your platform and software
release. To find information about the features documented in this module, and to see a list of the releases in
which each feature is supported, see the “Feature Information for Configuring ISG Integration with SCE”
section on page 14.
Use Cisco Feature Navigator to find information about platform support and Cisco IOS XE software
image support. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on
Cisco.com is not required.
Contents
• Prerequisites for Configuring ISG Integration with SCE, page 2
• Restrictions for Configuring ISG Integration with SCE, page 2
• Information About Configuring ISG Integration with SCE, page 2
• How to Configure ISG Integration with SCE, page 4
• Configuration Examples for ISG Integration with SCE, page 12
• Additional References, page 13
• Feature Information for Configuring ISG Integration with SCE, page 14
To Next Page
Loading...
Need help?
General