Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2006–2009 Cisco Systems, Inc. All rights reserved.
Configuring ISG Subscriber Services
First Published: March 20, 2006
Last Updated: March 2, 2009
Intelligent Services Gateway (ISG) is a Cisco IOS and Cisco IOS XE software feature set that provides
a structured framework in which edge devices can deliver flexible and scalable services to subscribers.
ISG defines a service as a collection of policies that can be applied to any subscriber session. This
module describes how ISG subscriber services work, how to configure services and traffic classes that
may be used to qualify policies defined within a service, and how to activate services.
Finding Feature Information
For the latest feature information and caveats, see the release notes for your platform and software
release. To find information about the features documented in this module, and to see a list of the releases in
which each feature is supported, see the “Feature Information for ISG Subscriber Services” section on
page 18.
Use Cisco Feature Navigator to find information about platform support and Cisco IOS XE software
image support. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on
Cisco.com is not required.
Contents
• Prerequisites for Configuring ISG Subscriber Services, page 2
• Restrictions for Configuring ISG Subscriber Services, page 2
• Information About ISG Subscriber Services, page 2
• How to Configure ISG Services on the Router, page 5
• Configuration Examples for ISG Services, page 15
• Additional References, page 18
• Feature Information for ISG Subscriber Services, page 18
To Next Page
Loading...
Need help?
General