Configuring ISG as a RADIUS Proxy
Additional References
15
class type control always event session-start
1 proxy aaa list RP
2 service-policy type service name service1
!
access-list 101 permit tcp host 10.45.45.2 any
The following example shows corresponding sample output from the show subscriber session
command:
Router# show subscriber session username 12345675@cisco
Unique Session ID: 66
Identifier: aash
SIP subscriber access type(s): IP
Current SIP options: Req Fwding/Req Fwded
Session Up-time: 00:00:40, Last Changed: 00:00:00
Policy information:
Authentication status: authen
Active services associated with session:
name "service1", applied before account logon
Rules, actions and conditions executed:
subscriber rule-map PROXYRULE
condition always event session-start
1 proxy aaa list RP
2 service-policy type service name service1
Session inbound features:
Feature: Layer 4 Redirect ------>>> L4 redirect is applied to the session at session start
Rule table is empty
Traffic classes:
Traffic class session ID: 67
ACL Name: 101, Packets = 0, Bytes = 0
Unmatched Packets (dropped) = 0, Re-classified packets (redirected) = 0
Configuration sources associated with this session:
Service: service1, Active Time = 00:00:40
Interface: FastEthernet0/1, Active Time = 00:00:40
Additional References
The following sections provide references related to ISG RADIUS proxy.
Related Documents
Standards
Related Topic Document Title
ISG commands Cisco IOS Intelligent Services Gateway Command Reference
Standard Title
None —
To Next Page
Loading...
Need help?
General