Cisco IR1101 - DSL SFP Module

SFP-VADSL2+-I was evaluated to country specific regulatory requirements only. The product was not
evaluated to IEC 61850-3 and IEEE1613 substation / utility standards.
Note
DSL SFP Overview
The DSL SFP interface is an 8 pin modular jack. The following table shows the pin-out assignments:
Pin AssignmentPin Number
Not Used1
Not Used2
Not Used3
Analog Input4
Analog Input5
Not Used6
Not Used7
Not Used8
The modular jack pin-outs are shown in the following graphics:
Product Overview
20
Product Overview
DSL SFP Overview