11
Getting Started and Product Document of Compliance for the Cisco IR809 Integrated Services Router
78-100612-01A0
Cisco® 809 Industrial Integrated Services Routers are certified to the requirements of RSS-210. The use
of this device in a system operating either partially or completely outdoors may require the user to obtain
a license for the system according to the Canadian regulations. For further information, contact your
local Industry Canada office.
This device has been designed to operate with antennas having a maximum gain of 6 dBi. Antennas
having a gain greater than 6 dBi are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotopically radiated power (EIRP) is not more than that permitted for successful
communication.
European Community, Switzerland, Norway, Iceland, and Liechtenstein
Cisco® 809 Industrial Integrated Services Router PID
• IR809G-LTE-GA-K9 - Compact Cisco IR809 Ruggedized Secure Multi-Mode 4G LTE M2M ISR
with Qualcomm MDM9215 for Australia and Europe, LTE 800/900/1800/2100/2600 MHz,
850/900/1900/2100 MHz UMTS/HSPA+ bands.
Declaration of Conformity with regard to the R&TTE Directive 2014/53/EC & Medical Directive
93/42/EEC
The following standards were applied:
• EMC-EN 301.489-1 v1.9.2; EN 301.489-17 v2.2.1
• Health & Safety-EN60950-1: 2005; EN 50385: 2002
• Radio-EN 300 328 v 1.9.1; EN 301.893 v 1.7.1, EN62311
The conformity assessment procedure referred to in Article 10.4 and Annex III of Directive 2014/53/EC
has been followed.
This device also conforms to the EMC requirements of the Medical Devices Directive 93/42/EEC.
Note This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to
certain frequencies and/or may require a license for operation. For more details, contact Cisco Corporate
Compliance.
The product carries the CE Mark:
To Next Page
Loading...
Need help?
General
