Installing the Router
This chapter describes the equipment and the procedures for successfully installing the Cisco IR809.
Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not
stack routers on a desktop. Excessive weight on top of the router could damage the chassis.
Caution
Do not install the router or power supplies next to a heat source of any kind, including heating vents.Caution
Read the installation instructions before connecting the system to the power source. Statement 1004Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
No user-serviceable parts inside. Do not open. Statement 1073Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it
can come into contact with such circuits. When installing the antenna, take extreme care not to come into
contact with such circuits, because they may cause serious injury or death. For proper installation and
grounding of the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National
Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
Warning
Cisco 809 Industrial Integrated Services Router Hardware Installation Guide
1
To Next Page
Need help?
General
