Cisco IR809 Installation Instructions

4G (MIMO)3G (Diversity)2GCarrierModem ChipsetsProduct
B4 - UMTS
AWS
B13 -
UMTS-700
B25 - PCS 1900
BC0 - CDMA
-800
BC1 - CDMA -
1900
BC10 - CDMA
-800
BC0 - CDMA
-800
BC1 - CDMA -
1900
BC10 - CDMA
-800
Verizon
Sprint
MDM9615
WTR1605L
PM8018
MC7350
B2 - UMTS
1900
B4 - UMTS
AWS
B5 - UMTS 850
B7 -
UMTS-2600
B17 -
UMTS-700
B2 - UMTS
1900
B4 - UMTS
AWS
B5 - UMTS 850
Quad GSMATT
Canada
MDM9215
WTR1605L
PM8018
MC7354
B1 - UMTS
2100
B3 - UMTS
1800
B7 -
UMTS-2600
B8 - UMTS 900
B20 - UMTS -
E800
B1 - UMTS
2100
B2 - UMTS
1900
B5 - UMTS 850
B6 - UMTS 800
B8 - UMTS 900
Quad GSMEurope
New Zealand
Australia
MDM9215
WTR1605L
PM8018
MC7304
Installing Antennas
There are two TNC connectors on the backside of the device. The TNC connectors are used to connect to the
4G modem. The SMA connector is for the GPS antenna.
Orient the antennas. For optimum wireless performance, the antennas should be perpendicular with respect
to the floor.
If the router is being mounted on a desk, orient the antennas straight up.
To attach the radio antennas to your wireless router, follow these steps:
Before You Begin
Before you install the Cisco 809 Integrated Services Router on a table, wall, or DIN rail, install the antennas
on the back panel. It is difficult to install the antennas after the router is installed.
In some cases it is necessary to install two antennas:
Cisco 809 Industrial Integrated Services Router Hardware Installation Guide
5
Installing the Router
Installing Antennas

Cisco IR809 Specifications

General

Brand	Cisco
Model	IR809
Category	Network Router
Language	English