Cisco IR809 Installation Instructions

Step 3
Route the cables so that they do not put a strain on the connectors or mounting hardware. To comply with IP 40, cables
should be routed down relative to the router to prevent water from traveling on the cables.
Installing a DIN Rail
The DIN Rail can be installed in two different orientations. With the cable side of the device facing up or
down. The DIN Rail bracket can be mounted on the front or the back of the router.
The IR809 meets IP30 rating when mounted vertically.Note
To attach the Cisco IR809 to a DIN rail, follow these steps:
Before You Begin
The DIN Rail kit is ordered separately.
Step 1
Attach the DIN rail bracket to the back of the router. Align the DIN rail bracket on the back of the router and secure/attach
it to the 4 mounting points using the screws provided. See the following figure.
Cisco 809 Industrial Integrated Services Router Hardware Installation Guide
8
Installing the Router
Installing a DIN Rail

Cisco IR809 Specifications

General

Brand	Cisco
Model	IR809
Category	Network Router
Language	English