Cisco MDS 9148 - Installing the Sfps; Powering up the Switch

4
Send documentation comments to mdsfeedback-doc@cisco.com
4 Installing the SFPs
Install one of the following SFPs in each empty port:
• A Fibre Channel Shortwave 1-, 2-, 4-, or 8-Gbps SFP transceiver, part number DS-SFP-FC8G-SW
• A Fibre Channel Long wavelength 1-, 2-, 4-, or 8-Gbps SFP transceiver, part number DS-SFP-FC8G-LW
• A Fibre Channel Short wavelength 1-, 2-, or 4-Gbps SFP transceiver, part number DS-SFP-FC4G-SW
For SFP installation, see Figure 4.
Figure 4 SFP Installation
13 1415
16 1718 1
9 20 21 22 23 24
1
81666
5 Powering Up the Switch
To power up the switch, follow these steps:
Step 1 Ground the switch, as shown in Figure 5.