Cisco MDS 9396T User Manual

Requirements Specific to Solid-Walled Cabinets
In addition to the requirements listed in the General Requirements for Cabinets and Racks section, solid-walled
cabinets must meet the following requirements:
• The rack must have a roof-mounted fan tray and an air-cooling scheme in which the fan tray pulls air in
at the bottom of the cabinet and sends it out from the top, with a minimum airflow of 849.5 m3/h exiting
the cabinet roof through the fan tray, should be available.
• The front and rear doors, and side panels, must be installed and nonperforated so that air flows predicatably
from bottom to top.
• The overall cabinet depth should be 36 to 42 in. (91.4 to 106.7 cm) to allow the doors to close and to
facilitate adequate airflow.
• The open area of the floor air intake must be a minimum of 150 sq. in. (968 sq. cm).
• The lowest piece of equipment should be installed at a minimum of 1.75 in. (4.4 cm) above the floor
openings to prevent blocking the floor intake.
Cisco MDS 9396T Multilayer Fabric Switch Hardware Installation Guide
19
Cabinet and Rack Installation
Requirements Specific to Solid-Walled Cabinets

Cisco MDS 9396T Specifications

General

Brand	Cisco
Model	MDS 9396T
Category	Switch
Language	English