CHAPTER 4
Installing the Cisco MDS 9396T Switch
This chapter describes how to install the Cisco MDS 9396T switch and its components.
Before you install, operate, or service the system, see the Regulatory Compliance and Safety Information for
the Cisco MDS 9000 Family for important safety information.
Note
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each
warning to locate its translation in the translated safety warnings that accompanied this device. Statement
1071
SAVE THESE INSTRUCTIONS
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
• Preinstallation, on page 22
• Installing the Switch, on page 30
• Grounding the Switch, on page 34
• Installing and Remvoing Components, on page 35
Cisco MDS 9396T Multilayer Fabric Switch Hardware Installation Guide
21
To Next Page
Loading...
