Cisco MDS 9396T User Manual

APPENDIX A
Cable and Port Specifications
This appendix includes the cables and connectors used with the Cisco MDS 9396T Multilayer Fabric Switch.
We strongly recommend that power cable runs and other potential noise sources be located as far away as
practical from network cabling that terminates on Cisco equipment. In situations where long parallel cable
runs exist but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these potential noise
sources. To avoid interference, the source should be shielded by housing it in a grounded metallic conduit.
Caution
• Cables and Adapters, on page 53
• Console Port, on page 54
• MGMT 10/100/1000 Ethernet Port, on page 55
• Supported Power Cords and Plugs, on page 57
Cables and Adapters
The Cisco MDS 9396T Switch accessory kit includes the following:
• RJ-45 to RJ-45 rollover cable
• RJ-45 to DB-9 female DTE adapter (labeled “Terminal”)
• RJ-45 to DB-25 female DTE adapter (labeled “Terminal”)
• RJ-45 to DB-25 male DCE adapter (labeled “Modem”)
Additional cables and adapters can be ordered from your customer service representative.
Note
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support. If
you purchased this product directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/c/en/us/support/index.html.
Note
Cisco MDS 9396T Multilayer Fabric Switch Hardware Installation Guide
53

Cisco MDS 9396T Specifications

General

Brand	Cisco
Model	MDS 9396T
Category	Switch
Language	English