Cisco ME 1200 Series - Page 28

2-14
Cisco ME 1200 Series Carrier Ethernet Access Devices Hardware Installation Guide
OL-31962-04
Chapter 2 Installing the Cisco ME 1200 NID
Initial Configuration
Controller(config-controller)#ProvisionNIDMgmtType
Controller(config-controller-ProvisionNIDMgmtType)#setiproute
setIpRouteReq ??ipv4_address 0.0.0.0
Controller(config-controller-ProvisionNIDMgmtType)#setiproute
setIpRouteReq ipv4_mask 0.0.0.0
Controller(config-controller-ProvisionNIDMgmtType)#setiproute
setIpRouteReq gateway_ip 7.6.0.1
Controller(config-controller-ProvisionNIDMgmtType)#setiproute commit
Step 9 Configure the connected Cisco ME1200 NID interface as trunk and allow the specified VLAN.
Controller#conf t
Controller(config)#controller nid 1/1
Controller(config-controller)#ProvisionPortVlanPortType
Controller(config-controller-ProvisionPortVlanPortType)# modifySwPort
modifySWPortConfig interface 1
Controller(config-controller-ProvisionPortVlanPortType)#modifySwPort
modifySWPortConfig mode trunk allowed vlan 2
Controller(config-controller-ProvisionPortVlanPortType)#modifySwPort
commit
Step 10 After above steps, using ‘platform nid-controller’ add the NID with the desired IP.
Controller#conf t
Controller(config)#platform nid-controller add 7.6.15.59
Controller(config)#end
Step 11 Check if the Cisco ME1200 NID has been added to UPE NID Controller,
Controller#show platform nid-controller nids
NID_ID MAC Address IP Address Lease Physical Port VLAN
TFTP Server Type
1 n/a 192.0.2.1 n/a n/a n/a
n/a static
2 n/a 7.6.15.59 n/a n/a n/a
n/a static
Step 12 Now, using ‘controller nid 1/2’ the Cisco ME1200 NID can be accessed on a different SVI.