Cisco ME 1200 Series - Chapter 3: AC and DC Input Power; AC Power Cord Retainer Clip Installation

CHAPTER
3-1
Cisco ME 1200 Series Carrier Ethernet Access Devices Hardware Installation Guide
OL-31962-04
3
AC and DC Input Power
This chapter provides the installation instructions for the AC and DC input power for the Cisco ME1200
NID
switches
• Installing an AC Power Cord Retainer Clip, page 3-1
• Installing an AC Power Cord, page 3-2
• Installing an AC-to-DC Power Adapter, page 3-2
• Wiring the DC Input Power Source, page 3-3
• Grounding the Switch, page 3-4
Installing an AC Power Cord Retainer Clip
Follow these steps to install a AC power cord retainer clip on the switch.
Step 1 Press the both side of the retainer clip and installing retainer clip through the hole on the hex screws.(see
figure 3-1)