Cisco Meraki MX64 User Manual

• Choose Web proxy > Yes.
• Enter values as appropriate for Hostname or IP and Port.
• If you require authentication, choose Authentication > Use authentication, and enter appropriate values for
Username and Password.
Configuring physical link settings
To configure physical link settings on the Ethernet ports, click Local status > Ethernet configuration. You can enable
half duplex, full duplex, and autonegotiation, as well as set 10- or 100-Mbps data rates.
To apply all configuration settings to the appliance, be sure to click Save Settings at the bottom of the page.
6

Cisco Meraki MX64 Specifications

General

Total Stateful Firewall Throughput	250 Mbps
Advanced Security Throughput	100 Mbps
Concurrent VPN Tunnels	50
WAN Interfaces	2 x GbE
LAN Interfaces	4 x GbE