Cisco NCS 5500 Series

Figure 62: Removing a Fan Tray from the Chassis
Pull on the fan tray to slide it out of the chassis. Set
the fan tray on an antistatic surface.
3Unscrew four captive screws (two at the top of the
module and two at the bottom of the module).
1
Hold the two fan tray handles with your two hands.2
b) Hold both handles on the front of the fan tray with both of your hands and pull the fan tray out of the slot.
c) Set the fan tray on antistatic material or inside an antistatic bag.
Step 4 Remove the fabric card that you are replacing by following these steps:
a) Unscrew the screw on the center of each of the two handles on the fabric card (see Callout 1 in the following figure).
Hardware Installation Guide for Cisco NCS 5500 Series Modular Routers
112
Replace Chassis Components
Removing a Fabric Card