Figure 13: Move Chassis onto a Rack
Rack vertical mounting rails
on the rack.
3Push the sides of the lower
half of the front side of the
chassis.
1
Bottom-support rails.4Chassis mounting brackets.2
To adjust the placement of the chassis on the bottom-support rails, you can use the chassis handles (see Callout
1 in the figures).
Tip
Step 4 Push the chassis all the way onto the rack so that the vertical mounting brackets on the front of the chassis come in contact
with the vertical mounting rails on the rack.
Step 5 Use four M6 x 19 mm or 24 x 3/4-inch screws to attach each of the two chassis vertical mounting brackets to the two
rack vertical mounting rails (total of eight screws). See Callout 2 in the figures.
Hardware Installation Guide for Cisco NCS 5500 Series Modular Routers
43
Install the Chassis
Mount Chassis Into the Rack
To Next Page
Loading...
