CHAPTER 4
Connecting the Switch to the ACI Fabric
• ACI Fabric Topology, on page 25
• Preparing to Connect to Other Devices, on page 26
• Connecting Leaf Switches to APICs, on page 27
• Connecting Leaf Switches to Spine Switches, on page 29
• Migration of Nodes From a First Generation Switch to a Second Generation Switch, on page 30
• Setting Up an Optional Console Interface, on page 32
• Setting Up an Optional Management Connection, on page 33
• Maintaining Transceivers and Optical Cables, on page 33
ACI Fabric Topology
The ACI fabric topology includes the following major components:
• Application Centric Infrastructure Controller (APIC) appliance (cluster of APICs)
• Leaf switches (for switch compatibility, please see the data sheets).
• Spine switches (for switch compatibility, please see the data sheets).
For additional information, please see the Cisco APIC Installation, Upgrade, and Downgrade Guide.
To prevent sub-optimal forwarding between endpoints, connect every leaf switch in the fabric to every spine
switch in the same fabric.
Note
As shown in the following figure, each APIC is connected to one or two leaf switches and each leaf switch
should be connected to every spine switch in the same fabric.
Cisco Nexus 9332D-GX2B ACI-Mode Switch Hardware Installation Guide
25
To Next Page
Loading...
