c) Tighten the 10-32 screws to 20 in-lb (2.26 N·m) or tighten the 12-24 screws to 30 in-lb (3.39 N·m).
Step 6 Insert the retainer clip to hold the chassis in place.
a) Align the retainer clip to the inside of the back of the slider rail. Make sure to hook the flange to the cutout on the
bracket and align the screw holes (see the following figure).
b) Attach the screws to secure the retainer clip (see the following figure).
c) Repeat Step 6 to attach the other retainer clip on the other side of the chassis.
Cisco Nexus 93360YC-FX2 NX-OS Mode Switch Hardware Installation Guide
24
Installing the Chassis
Installing the Switch using the NXK-ACC-RMK-2RU Rack-mount Kit
To Next Page
Loading...
