8 Cisco Nexus 9372PX Switch Configuration Guide for Dell PS Series SANs | SCG3665
The following configuration will be applied:
<Your settings will be displayed>
Would you like to edit the configuration? (yes/no) [n]:n
Use this configuration and save it? (yes/no) [y]:y
[########################################] 100%
Copy complete.
Log into the switch using the credentials created previously.
2.4 Enable LLDP
switch#config
switch(config)#feature lldp
switch(config)#interface ethernet 1/1-48
switch(config-if-range)#lldp receive
switch(config-if-range)#lldp transmit
switch(config-if-range)#exit
2.5 Disable Data Center Bridging (DCB)
All steps in this section are required in order to properly disable DCB.
Note: By default, DCB is enabled. This document provides steps to disable DCB. Perform all operations
during a maintenance window, because a temporary loss of communication between host servers and
storage arrays may occur.
switch(config)#lldp tlv-select dcbxp
switch(config)#copy running-config startup-config
switch(config)#no lldp tlv-select dcbxp
switch(config)#copy running-config startup-config
2.6 Configure the vPC domain
switch(config)#feature lacp
switch(config)#feature vpc
switch(config)#vpc domain 1
switch(config-vpc-domain)#peer-keepalive destination peer IP address
--------:: Management VRF will be used as the default VRF ::--------
switch(config-vpc-domain)#exit
To Next Page
Loading...
