Cisco ONS 15501 - Ethmode

4-8
Cisco ONS 15501 User Guide
78-14134-01, Release 1.0
Chapter 4 Command Reference
ethmode
ethmode
To display or modify the Ethernet boot mode, use the ethmode command.
ethmode mode
Syntax Description
Defaults Displays the current Ethernet boot mode.
Command Types Changes configuration
Command Modes Master password protected
Command History
Usage Guidelines The system default Ethernet boot mode is 3 for full-duplex 10 Mbps.
After setting a new Ethernet boot mode, the system must be rebooted to effect the change.
Examples The following example shows how to display the Ethernet boot mode.
edfa > ethmode
ethernet init-mode 4
The following example shows how to modify the Ethernet boot mode.
edfa > ethmode 3
ethernet init-mode updated to 3
mode Specifies the Ethernet boot mode. The boot mode is specified as 0
for auto-sense; 1 for full-duplex 100 Mbps; 2 for half-duplex 100
Mbps; 3 for full-duplex 10 Mbps; or 4 for half-duplex 10 Mbps.
Release Modification
EDFA 1.0 This command was introduced.