Cisco ONS 15501 - Ntp

4-22
Cisco ONS 15501 User Guide
78-14134-01, Release 1.0
Chapter 4 Command Reference
ntp
ntp
To modify or display the NTP (Network Time Protocol) status for the system, use the ntp command.
ntp [status]
Syntax Description
Defaults Displays the current configuration of the NTP (that is, on or off), as well as the current IP addresses of
the primary and secondary NTP servers
Command Types Changes configuration
Command Modes User password protected
Command History
Examples The following example shows how to enable the NTP for the system.
edfa > ntp on
The following example shows how to display the current configuration of the NTP.
edfa > ntp
ON, 209.128.68.149, 209.128.68.147
Related Commands
status Specified as on to enable the NTP, or as off to disable the NTP.
Release Modification
EDFA 1.0 This command was introduced.
Command Description
ntp-ip Modifies the IP addresses of the NTP server.