Cisco PenTeleData 8800 Series Administration Guide

DescriptionParameter
Indicates whether extended function is enabled.Extended Function Status
Line Call Status
DescriptionParameter
Status of the call.Call State
Type of tone that the call uses.Tone
Codec used for encoding.Encoder
Codec used for decoding.Decoder
Direction of the call.Type
Indicates whether the far end placed the call on hold.Remote Hold
Indicates whether the call was triggered by a call back
request.
Callback
The port mapped for Real Time Protocol traffic for
the call.
Mapped RTP Port
Name of the internal phone.Peer Name
Phone number of the internal phone.Peer Phone
Duration of the call.Duration
Number of packets sent.Packets Sent
Number of packets received.Packets Recv
Number of bytes sent.Bytes Sent
Number of bytes received.Bytes Recv
Number of milliseconds for decoder latency.Decode Latency
Number of milliseconds for receiver jitter.Jitter
Number of milliseconds for delay in the RTP-to-RTP
interface round trip.
Round Trip Delay
Number of packets lost.Packets Lost
The fraction of RTP data packets from the source lost
since the beginning of reception. Defined in
RFC-3611—RTP Control Protocol Extended Reports
(RTCP XR).
Loss Rate
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
252
Cisco IP Phone Troubleshooting
Line Call Status

Cisco PenTeleData 8800 Series Specifications

General

Brand	Cisco
Model	PenTeleData 8800 Series
Category	IP Phone
Language	English