Cisco PenTeleData 8800 Series Administration Guide

DescriptionParameter
Cadence script for distinctive ring 4.
Defaults to 60(.4/.2,.3/.2,.8/4).
Cadence 4
Cadence script for distinctive ring 5.
Defaults to 60(.2/.2,.2/.2,.2/.2,1/4).
Cadence 5
Cadence script for distinctive ring 6.
Defaults to 60(.2/.4,.2/.4,.2/4).
Cadence 6
Cadence script for distinctive ring 7.
Defaults to 60(4.5/4).
Cadence 7
Cadence script for distinctive ring 8.
Defaults to 60(0.25/9.75)
Cadence 8
Cadence script for distinctive ring 9.
Defaults to 60(.4/.2,.4/2).
Cadence 9
Control Timer Values (sec)
DescriptionParameter
Delay after far end hangs up before reorder (busy)
tone is played. 0 = plays immediately, inf = never
plays. Range: 0–255 seconds. Set to 255 to return the
phone immediately to on-hook status and to not play
the tone.
Reorder Delay
Long timeout between entering digits when dialing.
The interdigit timer values are used as defaults when
dialing. The Interdigit_Long_Timer is used after any
one digit, if all valid matching sequences in the dial
plan are incomplete as dialed. Range: 0–64 seconds.
Default: 10
Interdigit Long Timer
Short timeout between entering digits when dialing.
The Interdigit_Short_Timer is used after any one digit,
if at least one matching sequence is complete as
dialed, but more dialed digits would match other as
yet incomplete sequences. Range: 0–64 seconds.
Default: 3
Interdigit Short Timer
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
297
Cisco IP Phone Troubleshooting
Control Timer Values (sec)

Cisco PenTeleData 8800 Series Specifications

General

Brand	Cisco
Model	PenTeleData 8800 Series
Category	IP Phone
Language	English