Cisco RV134W

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 23
3
In the IPoA Settings section, enter the following information:
In the Other Settings section, enter the following information:
Virtual Circuit The Virtual Path Identifier (VPI) and
Virtual Channel Identifier (VCI) are
values used to identify your line to your
ISP’s ATM network.
SRA (Seamless Rate Adaption) Check Enable or Disable to enable or
disable the SRA, a protocol which, by
decoupling the modulation and
framing layer, can change the
transmission data rate parameters
(applied by the modulation layer).
DSL Modulation Select the DSL modulation from the
drop-down list. The default DSL
modulation is Multimode
(recommended).
Internet IP Address Enter the IP address (Hint 192.168.100.100).
Subnet Mask Enter the subnet mask (Hint 255.255.255.0).
Default Gateway Enter the default gateway (Hint 192.168.100.1).
Static DNS 1 & 2 Enter the IP address of the primary and or
secondary Static DNS in the fields (Hint 1.2.3.4).
NAT (Network
Address Translation)
If enabled, all outbound traffic through this interface is
NAT’ed. If disable, all outbound traffic through this
interface is routed.
MTU (Maximum
Transmission Unit)
MTU is an advanced configuration that allows you to
determine the largest data size permitted on your
connection. Select Auto (default) or Manual to
configure manually.
Size Enter the size of bytes. (Range 576 - 1500, Default
1500).