VPN
Site-to-Site IPsec VPN
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 103
6
• Local WAN (Internet) IP Address— Is generated automatically.
• In the Secure Connection Remote Accessibility fields, enter the following
information:
• Remote LAN (Local Network) IP Address—The private network (LAN)
address of the remote endpoint. This is the IP address of the internal network
at the remote site.
• Remote LAN Subnet Mask—The private network (LAN) subnet mask of the
remote endpoint.
• Local LAN (Local Network) IP Address—The private network (LAN)
address of the local network. This is the IP address of the internal network
on the device.
• Local LAN (Local Network) Subnet Mask—The private network (LAN)
subnet mask of the local network.
NOTE The remote WAN and remote LAN IP addresses cannot exist on the same subnet.
For example, a remote LAN IP address of 192.168.1.100 and a local LAN IP address
of 192.168.1.115 causes a conflict when traffic is routed over the VPN. The third
octet must be different so that the IP addresses are on different subnets. For
example, a remote LAN IP address of 192.168.1.100 and a local LAN IP address of
192.168.2.100 is acceptable.
STEP 6 Click Save.
Viewing Default Values
Click View Default Settings to view the default values used in the basic VPN
settings. These values are proposed by the VPN consortium and assume that you
are using a pre-shared key, or password that is known to both your device and the
remote endpoint.
Configuring VPN Advanced Parameters
Advanced VPN parameters such as IKE and other VPN policies control how the
device initiates and receives VPN connections.
To configure advanced VPN parameters, choose VPN > Site-to-Site IPsec VPN >
Advanced VPN Setup.
To Next Page
Loading...
Need help?
General
