Cisco RV134W

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 38
3
In the IPv6 Settings section, enter the following information:
For IPv6
DNS Server Source Select Get Dynamically from ISP or Use These
DNS Servers to manually configure.
Static DNS 1 & 2 Enter the IP address of the primary and or
secondary Static DNS in the fields (Hint 1.2.3.4).
Connect on Demand
Max Idle Time
Select this option if your ISP charges when you are
connected to the Internet. If you select this option,
the Internet connection is on - only when traffic is
present. If the connection is idle - no traffic is
flowing - the connection is closed. If you Connect
on Demand, enter the number of minutes after
which the connection shuts off in the Max Idle Time
field.
Keep Alive When you select this option, the Internet
connection is always on. In the Redial Period field,
enter the number of seconds after which the
device attempts to reconnect if it is disconnected.
Authentication Type Select the authentication type from the drop-down
list.
Auto Negotiation - The server sends a
configuration request specifying the security
algorithm set on it. The device then sends back
authentication credentials with the security type
sent by the server.
PAP - Password Authentication Protocol.
CHAP - Challenge Handshake Authentication
Protocol.
MS-CHAP - Microsoft version of the Challenge-
Handshake Authentication Protocol.
MS-CHAP2 - Microsoft version of the Challenge-
Handshake Authentication Protocol version 2.
Service Name Enter the service name.
Mode IPv6