Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 63
3
STEP 4 Enter the following information to configure the server settings (DHCPv6):
STEP 5 In the IPv6 Address Pool Table, click Add Row and enter the following
information.
STEP 6 Click Save.
To edit the settings of a pool, select the pool and click Edit. To delete a selected
pool, click Delete. Click Save to apply changes.
DHCP Status Check to enable the DHCPv6 server.
When enabled, the device assigns an IP address
within a specified range and provides additional
information to any LAN endpoint that requests
DHCP addresses.
Domain Name (Optional) Domain name of the DHCPv6 server.
Server Preference Server preference level of this DHCP server. DHCP
advertise messages with the highest server
preference value to a LAN host are preferred over
other DHCP server advertise messages.
The default is 255.
DNS Server Select DNS Server name from the drop-down list.
Static DNS 1 IPv6 address of the primary DNS server on the ISP
IPv6 network.
Static DNS 2 IPv6 address of the secondary DNS server on the
ISP IPv6 network.
Client Lease Time Client lease time duration (in minutes) for which
IPv6 addresses are leased to endpoints on the
LAN.
Start Address Starting IPv6 address of the pool.
End Address Ending IPv6 address of the pool.
IPv6 Prefix Length Prefix length that determines the number of
common initial bits in the network addresses.
To Next Page
Loading...
Need help?
General
