IP Configuration
IPv4 Management and Interfaces
261 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
15
- Static—Entered manually. Static interfaces are non-DHCP interfaces that created
by the user.
- Default—The default address that exists on the device by default, before any
configurations have been made.
• IP Address—Configured IP address for the interface.
• Mask—Configured IP address mask.
• Status—Results of the IP address duplication check.
- Tentative—There is no final result for the IP address duplication check.
- Valid—The IP address collision check was completed, and no IP address collision
was detected.
- Valid-Duplicated—The IP address duplication check was completed, and a
duplicate IP address was detected.
- Duplicated—A duplicated IP address was detected for the default IP address.
- Delayed—The assignment of the IP address is delayed for 60 second if DHCP
Client is enabled on startup in order to give time to discover DHCP address.
- Not Received—Relevant for DHCP Address. When a DCHP Client starts a
discovery process, it assigns a dummy IP address 0.0.0.0 before the real address is
obtained. This dummy address has the status of “Not Received”.
STEP 3 Click Add.
STEP 4 Select one of the following fields:
• Interface—Select the port, OOB port, LAG, Loopback or VLAN as the interface
associated with this IP configuration, and select an interface from the list.
• IP Address Type—Select one of the following options:
- Dynamic IP Address—Receive the IP address from a DHCP server.
- Static IP Address—Enter the IP address.
STEP 5 If Static IP Address was selected, enter the Mask field:
• IP Address—Enter the IP address of the interface.
• Network Mask—IP mask for this address.
• Prefix Length—Length of the IPv4 prefix.
To Next Page
Loading...
