Cisco SPA 301 - Outbound Call Codec Selection Codes

Configuring Regional Parameters and Supplementary Services
Vertical Service Announcement Codes (Cisco SPA 300 and Cisco SPA 500 Series)
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide 166
7
6) Block Caller ID
BCT: Block caller id enabled
BCF: Block caller id disabled
7) Distinctive Ringing
DRT: Distinctive ringing enabled
DRF: Distinctive ringing disabled
8) Speed Dial
SDT: Speed dial enabled
SDF: Speed dial disabled
9) Secure Call
SCT: Secure call enabled
SCF: Secure call disabled
10) Do Not Disturb
DDT: DND enabled
DDF: DND disabled
11) Caller ID
CDT: Caller ID enabled
CDF: Caller ID disabled
12) CW CID
WDT: CWCID enabled
WDF: CWCID disabled
13) Block Anonymous call
BAT: Block anonymous call enabled
BAF: Block anonymous call disabled
Outbound Call Codec Selection Codes
Codec call selection codes affect voice quality. For more information about voice
codecs, see the “Supported Codecs” section on page 120.
• You can choose a
preferred codec for a call or force a call to use a specific
codec.
•
Prefer G.711u (*017110) through G.729a (*01729) —Sets the preferred
codec for next outbound call. If the preferred codec is unavailable, the
second, then the third preferred codec is used, if specified (see the
“Configuring Voice Codecs” section on page 125).
• Force
G.711u (*027110) through G.729a (*02729) —Forces the specified
codec for next outbound call. If the specified codec is unavailable, the
preferred codecs are used in order, if specified (see the “Configuring
Voice Codecs” section on page 125).