Getting Started
Using IVR on the Cisco SPA 301 and Cisco SPA 501G IP Phone
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide 22
1
131 Set a gateway. Enter the address (use * to enter the “.” value), then
press #.
To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
161 Set the address of the primary Domain Name Server (DNS). Enter the
address (use * to enter the “.” value), then press #.
To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
181 Set the IP multicast address (used by the Cisco SPA 9000 to
communicate with the IP phone). Enter the address (use * to enter the “.”
value), then press #.
To s a v e , p r e s s 1. To review the value you entered, press 2. To re-enter,
press 3. To exit, press *.
7932 Enable or disable the web-based configuration utility. Press 1 to enable
or 0 to disable, then press #.
To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
723646 Enable or disables access to the administrative (admin) login on the
configuration utility. Press 1 to enable or 0 to disable, then press #.
To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
Number Option
To Next Page
Loading...
